Projects:2016s1-122 A Complete Model for a Synchronous Machine
A Dynamic Model for a Synchronous Machine
Supervisor:
Dr Andrew Allison
Co-supervisor:
David Vowles
Project Members:
Leng Wai Kit Teng, Praveen De Silva, Thomas Klopf, Samuel Conlin
Aim:
To find a model for the Dynamic Characteristics of a synchronous machine. Then the model will be validated through a series of tests on an actual machine. The test procedures will be standardized and documents for use with other synchronous machines.
Motivation:
The steady state characteristics of the synchronous machines in the power labs at the University of Adelaide are already well documented, however information about the dynamic characteristics of these machines haven't been documented much. If a model and standardized test procedure to find the synchronous machines dynamic characteristics could be found, more information about the machines could be documented for future use by students and academics who wish to use them.
Validation of the machine model:
In order to validate the machine, various data points were obtained within the operating region of the machine. The capability figure shown below clearly indicates the operating region of the machine and it also shows the data points which the group calculated.
In order to obtain the data points, the group used the DC machine as a prime mover which drives power in to the synchronous machine which then drives power into the mains. Adjusting the prime mover by adjusting the rheostat on the DC machine allowed the group to obtain real power measurements and adjusting the field voltage by adjusting the rheostat on the synchronous machine allowed the group to obtain reactive power measurements.
The data points shown in the capability figure represents field current (A). Once these measurements were made, the group compared the measured values with the calculated values of field current. MATLAB code authored by Mr. David Vowles was used for the purpose of comparing measured results with the calculated results.
